BeadJewelryMaking - Jewelry Project

	Jewelry Project
	Featuring a beaded jewelry clasps in Free Beaded Jewelry project and Arts and Craft Project here, including Free pattern and instruction, beaded project and other project for Adults, Teens and Kid.

Beaded Jewelry Clasps

What you need:

1)    Nylon Fishing line (Any size less than 0.25mm)
2)    Beads
3)    Scissors

Step 1:

Cut a piece of fishing line (around 15 cm, depending on your bead size), string 5 beads and cross the string on the 5th bead and pull to tighten (rep by the red bead)

String another 4 beads on one end of the line and cross the string at the last bead. Tighten and string the line near the first bead circle (red) back to the second bead of the first five bead circle.

Step 2:

Continue to add 3 beads and cross the line through the last added bead.

String the line nearest to the first bead circle (red) back through the bead next to the last bead added.

Step 3:

Continue to add 3 beads and cross the line through the last added bead.

String the line nearest to the first bead circle (red) back through the bead next to the last bead added.

Now you should know the sequence so continue adding 3 beads again and repeat the above step.

The last step for now is to add 2 beads (not 3) and finish off again by crossing at the last added bead and string the end nearest to the next blue bead.

Step 4:

String 3 beads and cross the line through the last added bead.

String the line nearest to this bead back through 2 beads (Blue) next to the last bead added.

Step 5:

String 2 beads and cross the line through the last added bead.

String the line nearest to this bead back through 2 beads (Blue) next to the last bead added.

Repeat this step for two more times

For the last step add one bead and cross the lines through this bead

Step 6:

By now you should get a round bead ball, tie off and string the remaining string back into the beaded ball (no sequence).

You can now attach a new string to any bead from the bead ball and start making your necklace or bracelet.

Step 7:

After finishing your jewelry piece, end off by stringing 15 to 25 beads (measure around your bead ball) to form a loop and tie off.

Your jewelry clasps!

Other Project	Flower Project	Kid Art Bead Project
Bead Project	Adult Project	Basic Beading Techniques

Check out our Kid Art Project page or Photo Gallery for more Ideas
Disclaimer: The information in each project is submitted by our users and presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, BeadJewelryMaking.com disclaims any liability for untoward results or content. Important: Please be sure to thoroughly read the instructions for all products, paying particular attention to all cautions and warnings shown to ensure the proper and safe use of the product for child safety in accordance to age safety standards. Copyright: Users voluntarily submits their own content and the copyright belongs to the user themselves, but by submitting any and all information to BeadJewelryMaking.com users agrees that these information can be evaluated, use or not to use and amended by BeadJewelryMaking.com. All Rights Reserved. No part of this Project may be reproduced in any form without permission in writing, except for your personal use, except by reviewer, who may in reviewing this project, quote brief passages in a magazine or newspaper. The viewer is granted a limited, non-transferable one-time license to print one copy of each printable page for personal use without specific permission. Further copying, distribution or use of any of the material herein, including without limitation printable pages, is prohibited.